The Digitech XTD Tone Driver X Series Guitar Overdrive Pedal is
the world’s most advanced overdrive
pedal. DigiTech’s exclusive AudioDNA™ technology is what makes the
Tone Driver more than your standard overdrive stompbox. Rather than
working from a single overdrive circuit, the Tone Driver features a
Morph knob which blends between three totally distinct overdrive types.
You now get a wide variety of different overdrive sounds that can be
dialed in quickly and easily.
Level Knob
Controls the effect’s output level. Turn this knob clockwise to increase
the output level, and counter-clockwise to decrease output level.
Tone Knob
Controls the boost or cut of high frequencies. Turn this knob clockwise
to increase the high frequency content, and counter-clockwise to
decrease the high frequency content.
AC Adapter Jack
Connect a DigiTech PS200R power supply to this jack. Use the proper
supply for your area’s Mains line voltage.
Gain Knob
Controls the amount of overdrive distortion. Turn this knob clockwise
to increase the amount of distortion, and counter-clockwise to decrease
the amount of distortion.
Morph Knob
Morphs the three different overdrive voicings. The minimum position is
an edgy, mid boost overdrive. The 12 o’clock position is a smooth warm
overdrive sound. The maximum position is a classic overdrive with extra
gain for when you need it. Experiment with the knob’s different
positions to hear the wide variety of overdrive tones.
Input Jack
Connect your instrument to this jack. Connecting a guitar cable to this
jack engages battery power even though the Indicator LED may not be
lit. To prolong battery life, disconnect all cables from the pedal when not
in use.
Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the chassis exposing the
battery compartment. (See battery replacement diagram.)
Out 1(Amp) Jack
Connect this output to your guitar amplifier.
Out 2 (Mixer) Jack
This output features DigiTech’s CIT™ cabinet modeling technology, that
lets you run the pedal directly into a mixer or recorder input without
having to use a guitar amplifier.
Indicator LED
Indicates when the effect is turned on. If the LED becomes dim or does
not light when the cables are connected, the battery needs to be
replaced.
Connections
The Tone Driver has a single input (INPUT) and a pair of outputs (AMP
and MIXER). The two outputs give you the following options: running
into a guitar amplifier, or running directly to a mixing console or
recording device, or both. The MIXER output uses DigiTech’s advance
CIT™ cabinet modeling technology for an authentic guitar amplifier
sound without using an amp.
