Kustom KBA30X

• 30-Watt RMS Output
• 10" Celestion™ Bass Speaker
• 4-Band Active EQ
• EQ Notch Control
• Built In Limiter
• 1/4" Line Level Line Output

• External Speaker Jack
• CD/Tape Input
• Sealed Back Cabinet
• Dimensions - 15.3"H x 18.5"W x 13"D
• Dimensions (mm) - 380H x 450W x 310D
• Weight - 34 lbs/ 15.4 kg.

1) CD/Tape Input - this 1/4" 3 conductor jack will allow you to plug in a CD player, tape or any other source to practice along with. It sums the left and right signals into a mono signal. To control the volume of the source, adjust the output volume of the device.

2) Guitar Input - this is a 1/4" 2 conductor input jack for plugging in your instrument. It is intended for bass guitar or Hi-Z microphones but will accept other instruments as well.

3) Volume Level - this control is the output volume control for the bass guitar input. Slowly increase the control to increase the volume. If you are using a bass guitar with an on-board preamp, set it's level for a mid position before increasing this control otherwise distortion may occur.

4) Notch - this control is a dramatic cut filter.It is "notched" at a rate of -15db. The width of the notch is set at one octave and can be swept from 45Hz to 1KHz. It will create a very precise subtraction of the undesired overtones or allow you to fine tune your tone settings.

5) Low - this control is the bass control. It is active and set to boost or cut frequencies at 100 Hz. This will effect the low frequency signals. Turning it fully clockwise, the signal is boosted 12db. Turning it counterclockwise, the low will be rolled off -12db. Especially good for making low output, thin toned bass guitars sound fuller.

6) Lo-Mid - this control is the Low Midrange control. It is active and set to boost or cut frequencies at 500 Hz. This will effect the mid-low frequency signals. Turning it fully clockwise, the signal is boosted 12db. Turning it counterclockwise, the highs will be rolled off -12db. Especially good for "cleaning up" muddy bass guitar overtones.

7) Hi-Mid - this control is the High Midrange control. It is active and set to boost or cut frequencies at 2 KHz. This will effect the mid-low frequency signals. Turning it fully clockwise, the signal is boosted 12db. Turning it counterclockwise, the highs will be rolled off -12db. Increasing this will add punch to a bass guitars' sound.

8) High - this is the high frequency control. It is passive and set to shelve frequencies at 3KHz. This will effect the high frequency signals. Turning it fully clockwise, the signal is boosted 12db. Turning it counterclockwise, the highs will be rolled off -12db. This will add or subtract the high end attack of slapping style sounds or pick attack and clarity.

9) Headphone Jack - this is a 1/4" 3 conductor jack for plugging headphones. It will sum the signal and put the sound in both ears, thereby creating a pseudo-stereo sound. Volume will be determined by the volume control on the channel you are on. It will disconnect the internal speaker when plugged in. This will allow quiet practicing.

10) Power - this switch turns on and off the AC power to the amp.

11) Power LED Light - this LED light lets you know that the amplifier is on.